1.1 These test methods cover the evaluation of fastener use with "as manufactured" plastic lumber and shapes through the use of two different testing procedures. 1.2 The test methods appear in the following order:
Sections
Test Method A-Nail, Staple, or Screw Withdrawal Test
4 to 13
Test Method B-Nail, Staple, or Screw Lateral Resistance Test
14 to 22
1.3 Plastic lumber and plastic shapes are currently made predominately from recycled plastics. However, these test methods would also be applicable to similar manufactured plastic products made from virgin resins where the product is non-homogeneous in the cross-section. 1.4 The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only. 1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.Note 1:There is no known ISO equivalent to this standard.1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Product Details
Published: 07/01/2023 Number of Pages: 9 File Size: 1 file , 450 KB Redline File Size: 2 files , 680 KB Note: This product is unavailable in Russia, Ukraine, Belarus